If you want to remove the stock factory speakers from the front or rear car doors for an upgrade, you need to remove the speaker grill correctly. Speakers from the factory are usually made from cheap paper cone materials and can't take high watts power from an external amp to give you that extra bass. They distort much more quickly and have a poor lifespan leading to being blown out easily. With an good quality set of aftermarket speakers, you will have the choice between a coaxial and component setup. If you follow an incorrect procedure, you could damage the clips on the door card or pull of the wires going to the switches on the panels. We as a car audio shop remove speakers from car doors on a daily basis, so we have the best instructions that are clear and easy to understand.
Now if you are considering upgrading the current car speakers without an amp they will still provide a significant difference to sound quality. The only difference with adding an external amp is that they will provide more spl volume and less distortion at higher volumes. The best way to make car speakers louder without an amp is to upgrade the factory CD player with an aftermarket. Pioneer, JVC and Alpine make good powered radios with true rms figures due to using mosfet technology. If you are wondering how to wire car speakers, you simply remove the old one and switch it over using the same wires.
The best car speakers to replace with the stock factory ones all depends on how much you wanna spend. But you got to remember if you want to the best performance, its essential to apply sound deadening material to the metal panels of the doors to stop road noise and vibrations.
Now if you are considering upgrading the current car speakers without an amp they will still provide a significant difference to sound quality. The only difference with adding an external amp is that they will provide more spl volume and less distortion at higher volumes. The best way to make car speakers louder without an amp is to upgrade the factory CD player with an aftermarket. Pioneer, JVC and Alpine make good powered radios with true rms figures due to using mosfet technology. If you are wondering how to wire car speakers, you simply remove the old one and switch it over using the same wires.
The best car speakers to replace with the stock factory ones all depends on how much you wanna spend. But you got to remember if you want to the best performance, its essential to apply sound deadening material to the metal panels of the doors to stop road noise and vibrations.
If you are wondering where to get speakers installed in your car, you don't need to look because realistically you can do it yourself. Instructions on how to remove car speakers from a car door the correct way as follows:
1) Turn off the cars ignition before removing the car speakers from the door. You don't want music to be playing from the stereo while disconnecting the speaker wires as this could cause a short.
2) Ok so you will need to find all of the screws that are holding the plastic dashboard trim door card in place. The speaker grill is attached onto it and when you remove it you can remove the speaker. You may need a flat head screwdriver to pull of the tabs to show the screws so that you can remove them. Once you have removed them, please ensure you place them into some plastic contained to prevent them getting lost as they are really tiny in size.
3) Now that the screws are removed that hold the door card in place, push it upwards from the bottom to lift it up. Once its lifted up pull it towards you so that all of clips are undone correctly. You may notice that behind it there are wires connecting to the window switches. What you need to do is unplug the wiring harness so that you can fully remove the door card.
4) Right you will now see the speaker positioned on the bottom corner. In most cases it will have around about four screws holding it down. Get a Philips head screwdriver and remove all of them. Then remove the speaker from the car door by removing the spade terminals that are fitted onto the back near the magnet.
5) You are now ready to fit your replacement brand new speakers, you may need additional spacers to accommodate for the size difference for the upgrade. Also you will need to remove the tweeter fitted either on the car door or a pillar if you are installing an component setup.
0 Comments: